SA-3

Power Amplifier

While many contemporary amplifiers waste 50% or more of the power they pull from the wall as heat, the SA-series amplifiers run at approximately 90% efficiency. As a result, more power is available for the loudspeaker, and less is wasted as heat in your room.

The high efficiency of the SA-series design also means that the amplifiers can be placed near each other, as in an equipment rack, without undue overheating.

Key Features

Three Channel
3 x 500-Watts
Cardas Connectors

Flat Stackable
2RU

High Efficiency Design
Enormous Power Reserves

Specification

Rated Power Output Per Channel	500 w/ch continuous rms power @ 4 ohms above power ratings from 20 Hz–20 kHz at <0.5% THD
Peak Output Current	> 30 amps
Voltage Gain	31 dB
Signal to Noise Ratio (Main Outputs)	–103 dB (ref 1V rms, A-wtd.)
Input Impedance	25k ohms (balanced)
Output Impedance	Less than 0.05 ohms from 20–20,000 Hz
Input Sensitivity	1.2V for full output
Polarity	Non-inverting, Pin 2 positive
Thermal Load	7 BTU/minute or less
Power Consumption	See Wisdom Electronics – Current Draw & BTU Info in the Resources Section below
Main Voltage Ranges	100V, 120V, or 230/240V determined by the needs of the country for which the unit was manufactured; cannot be reset by dealer or user
Shipping Weight	40 lbs. (19 kg)
Dimensions – HxWxD	3.5” x 17” x 13.63” (8.89cm x 43.2cm x 34.7cm)